GMX Coldwater Line Installation Examples

No Salt Water Softener - Salt Free Home Water Treatment System

100% Money Back GuarenteeNo Salt - Chemical Free
(888)-827-9052
Easy DO-IT-YOURSELF Installation


GMX Cold Water Pipe Installation Pictures

The GMX Devices can be place on copper and/or any type of plastic pipe. There are many ways to install the GMX devices. These pictures are just some examples. Questions, please call.

Click image for a large high resolution picture.

Click for Large High Resolution Image.
This customer's home had just enough room above the bricks and below the main cold water shut off valve on his front porch.

 

Click for Large High Resolution Image.
These GMX devices are mounted in the garage on the water softener loop pipe leaving his broken down Culligan salt based unit that was scheduled to be removed the next day. He elected not to treat his outside hose bibs.

 

Click for Large High Resolution Image.
Well System installation. The GMX devices are installed on the pipe leaving his pressure tank and feeding his home.

 

Click for Large High Resolution Image.
This is another well system installation. The GMX devices are installed on the pipe leaving his pressure tank and feeding his home.

Below is a cold water line installation done
by us on a new home in Scottsdale, Arizona
before the landscaping was in place.

The incoming (cold) water pipe was in the front yard.
Click image for a large high resolution picture.

Click for Large High Resolution Image.
A 15" deep hole was dug around the incoming (cold) water pipe prior to installing the these two devices.

 

Click for Large High Resolution Image.
The two devices are installed on the left side of pipe due to a slight curve to the lower right. The two devices are installed on the outside of the slight curve.

 
Click for Large High Resolution Image.
Close Up # 1
  Click for Large High Resolution Image.
Close Up # 2
 

Click for Large High Resolution Image.
After installing the two devices and the 15" deep hole was filled in.

 

Both units MUST be installed on the same side of the pipe as shown, with the arrows pointing the same direction. If you enlarge close up # 2, by clicking the image, you can barely see the outline of the arrow sticker of the top device on the right side.





FAQ's | Testimonials | Site Map | Contact Us | Privacy Policy

Email Us - (888)-827-9052 | 1146 N Mesa DR #102, Mesa AZ 85201

Copyright © Clearwater GMX All Rights Reserved.

PRchecker.info