No Salt Water Softener - Salt Free Home Water Treatment System

100% Money Back GuarenteeNo Salt - Chemical Free
(888)-827-9052
Easy DO-IT-YOURSELF Installation


GMX Hot Water Installation Pictures

The GMX Devices can be place on copper and/or any type of plastic pipe. There are many ways to install the GMX devices. These pictures are just some examples. Questions, please call.

Click image for a large high resolution picture.

Click for Large High Resolution Image.
It is usually not possible to install two devices in a straight line on the flex line of a water heater. Notice the GMX devices are installed on the pipe without the shut off valve.

 

Click for Large High Resolution Image.
Close up view of the installation to the left.

 

Click for Large High Resolution Image.
Like on the previous water heater, it is usually not possible to install two devices in a straight line on the flex line of a water heater. Notice the GMX devices are installed on the same side of the pipe and on the outside of the curve.

 

Click for Large High Resolution Image.
Close up view of the installation to the left.

 

Click for Large High Resolution Image.
This is a single device installation on a 40 gallon water heater. The GMX device is installed right up next to the wall. The straightest section of flex pipe.

 

Click for Large High Resolution Image.
This is an ideal water heater installation. 3" from each elbow.

Below is a water heater installation done
by us on a new home in Scottsdale, Arizona.

This gas water heater was in the garage next to the gas furnace.
Click picture for a large high resolution picture.

Click for Large High Resolution Image.
A 75 gallon water heater prior to installing two (2) GMX Model 800 device on the output (hot) pipe. The output (hot) pipe is the pipe without the water shut-off valve.

 

Click for Large High Resolution Image.
The same 75 gallon water heater after installing the two (2) GMX Model 800 devics on the output (hot) pipe. The shut-off valve (cold water in) can be seen right of the GMX devices on the other pipe in close up # 1.

 
Click for Large High Resolution Image.
Close Up # 1
  Click for Large High Resolution Image.
Close Up # 2
 
Click for Large High Resolution Image.
Close Up # 3
 

Both units MUST be installed on the same side of the pipe as shown, with the arrows pointing the same direction. The arrows are on the far side of the devices in close up # 3 and cannot be seen. In close up # 3, the devices are touching each other on the right side and there is a 1" separation on the left side.




FAQ's | Testimonials | Site Map | Contact Us | Privacy Policy

Email Us - (888)-827-9052 | 1146 N Mesa DR #102, Mesa AZ 85201

Copyright © Clearwater GMX All Rights Reserved.

PRchecker.info